Showing 21–40 of 42 results
Add to wishlist Compare Quick view
₹ 120Specifications
Wi-Fi Modes: Wi-Fi Direct (P2P), Soft-APProtocol Stack: Integrated TCP/IPProcessor: Low-power 32-bit CPUCommunication Interfaces: SDIO 1.1/2.0, SPI, UARTWireless Technologies: STBC, 1×1 MIMO, 2×1 MIMOFlash Memory: 1MB (upgraded from 512KB)GPIO Pins: 2 (for sensors and peripherals)Wake-up Time: <2msStandby Power Consumption: <1.0mW (DTIM3)Operating Voltage: 3.3V (requires logic level converter for 5V systems)Compatibility: Arduino, Raspberry Pi, PIC, and other microcontrollersDimensions: Compact form factor
Add to wishlist Compare Quick view
₹ 220Specifications:
Wireless Standards: 802.11 b/g/nFrequency Range: 2.4GHz – 2.5GHzData Interfaces: UART, HSPI, I2C, I2S, GPIO, PWM, IR Remote ControlOperating Voltage: 3.0V – 3.6V (Recommended: 3.3V)Average Current Consumption: 80mAOperating Temperature: -40°C to 125°C
PCB Size: 25mm × 16mm
Add to wishlist Compare Quick view
₹ 400Specifications:
4GHz Dual-Mode WiFi + Bluetooth Development Board, 38PIN
Ultra-Low power consumption works perfectly with the IDE
Support LWIP protocol, Freertos
Support Three Modes: AP, STA, and AP+STA
ESP 32 is safe, reliable, and scalable to a variety of applications
Add to wishlist Compare Quick view
₹ 840Specifications:
Ultra-Small 802.11b/g/n Wi-Fi + BT/BLE SoC module
Low-Power Dual-core 32-bit CPU for application processors
Up to 240MHz, up to 600 DMIPS
Built-in 520 KB SRAM, external 4M PSRAM
Supports Interfaces such as UART/SPI/I2C/PWM/ADC/DAC
Support OV2640 and OV7670 cameras with built-in flash
Support for images Wi-Fi upload
Support TF card
Add to wishlist Compare Quick view
₹ 40Specifications:
High Photo Sensitivity
Fast Response Time
Sensitivity adjustable
Wavelength range 760nm-1100 nm.
Detection range: up to 100 cm.
Adjustable detection range.
Detection angle about 60 degrees, it is sensitive to the flame spectrum.
Comparator chip LM393 makes module readings stable.
Operating voltage 3.3V-5V.
Digital and Analog Output.
Add to wishlist Compare Quick view
₹ 280Specifications
Parameter Details
Total Length 7.5 cm
Active Sensor Length 55 mm
Life Cycle > 1 million bends
Height 0.43 mm (0.017″)
Flat Resistance 10K Ohms ±30%
Bend Resistance Min. 20K Ohms ±30% (@ 180° pinch bend)
Power Rating 0.5W continuous, 1W peak
Add to wishlist Compare Quick view
₹ 70Specifications:
Operating Voltage: 5V DCStatic Current: < 2mAOutput Signal: 5V TTL pulseDetection Angle: < 15°Detection Range: 2cm to 400cmPrecision: Up to 2mmInput Trigger Signal: 10µs TTL pulseEcho Signal: TTL pulse width proportional to distance
Add to wishlist Compare Quick view
₹ 70Specifications:
Operating Voltage: 4V to 30V Temperature Range: -55°C to +150°C Output Voltage: 10mV per °C Accuracy: ±0.5°C (at 25°C) Power Consumption: 60 µA (Typical) Response Time: Less than 1 second Output Impedance: Low (less than 1Ω) Package Type: TO-92 / SOIC-8
Add to wishlist Compare Quick view
₹ 50Specifications:
Working voltage: DC 3.3-5V.
IC Chip: LM393
Signal output indication.
The output is digital.
Single channel signal output.
With the retaining bolt hole, convenient installation.
Output low level and the signal light when there is sound.
Add to wishlist Compare Quick view
₹ 120Specifications:
Sensitivity to Ammonia, Sulphide and Benzene steam
Sensitive for benzene, alcohol, smoke
Fast response and recovery
Adjustable sensitivity
Signal output indicator
Output voltage boosts along with the concentration of the measured gases increases.
Add to wishlist Compare Quick view
₹ 120📌 Specifications
🔹 Gas Detection : LPG, methane, hydrogen, propane, carbon monoxide, alcoholOperating Voltage : 5V DC Power Consumption : ~150mA Analog Output (AO) : 0-5VDigital Output (DO) : High/Low signal (threshold adjustable)Preheat Time : ~20 secondsResponse Time : <10 secondsOperating Temperature : -10°C to 50°CDimensions : 32mm x 22mm x 27mm
Add to wishlist Compare Quick view
₹ 120📌 Specifications
🔹 Gas Detection : Alcohol, ethanol vaporsOperating Voltage : 5V DC Power Consumption : ~150mA Analog Output (AO) : 0-5VDigital Output (DO) : High/Low signal (threshold adjustable)Preheat Time : ~20 secondsResponse Time : <10 secondsOperating Temperature : -10°C to 50°CDimensions : 32mm x 22mm x 27mm
Add to wishlist Compare Quick view
₹ 120Specifications:
Operating Voltage: 5V DC
High sensitivity to LPG, natural gas, town gas.
Small sensitivity to alcohol, smoke.
Stable and long life.
Simple drive circuit.
Fast response
Add to wishlist Compare Quick view
₹ 130📌 Specifications
🔹 Gas Detection : LPG, isobutane, propaneOperating Voltage : 5V DC Power Consumption : ~150mA Analog Output (AO) : 0-5VDigital Output (DO) : High/Low signal (threshold adjustable)Preheat Time : ~20 secondsResponse Time : <10 secondsOperating Temperature : -10°C to 50°CDimensions : 32mm x 22mm x 27mm
Add to wishlist Compare Quick view
₹ 130📌 Specifications
🔹 Gas Detection : Carbon Monoxide (CO)Operating Voltage : 5V DC Power Consumption : ~150mA Analog Output (AO) : 0-5VDigital Output (DO) : High/Low signal (threshold adjustable)Preheat Time : ~60 seconds Response Time : <10 seconds Operating Temperature : -10°C to 50°C Dimensions : 32mm x 22mm x 27mm
Add to wishlist Compare Quick view
₹ 280Specifications:
WiFi Module: ESP-12E
Processor: ESP8266
CP2102 Chip
Built-in Flash: 32Mbit
Antenna: Onboard PCB antenna
Peripheral interface: UART/SPI/I2C/SDIO/GPIO/ADC/PWM
WiFi Protocol: IEEE 802.11 b/g/n
Frequency Range: 2.4G ~ 2.5G (2400M ~ 2483.5M)
WiFi Mode: Station / SoftAP / SoftAP Station
Power Supply: 5V
Logic Level: 3.3V
Add to wishlist Compare Quick view
₹ 650Specifications:
Product: Raspberry Pi Pico WMicrocontroller: RP2040Flash Memory: 2MBProcessor: Dual-core Cortex-M0+ (up to 133MHz)
On-board single-band 2.4GHz wireless interfaces (802.11n)
Micro USB B port for power and data
40 pin 21mmx51mm ‘DIP’ style 1mm thick PCB
23 GPIO are digital-only, with three also being ADC capable
Add to wishlist Compare Quick view
₹ 110QUICK OVERVIEW:
All SD SPI pins output, MOSI, SCK, MISO, and CS.
Support 5V/3.3V input.
This module can handle 2GB SD cards.
Size:4.7 x 3.1 cm.
LED indicator.
SD Card Holder.
Onboard 3.3V regulator (AMS1117-3.3) for +5v to 3.3V generation. 3.3V is also available as output.
Add to wishlist Compare Quick view
₹ 50Specifications:
Operating Voltage 3.3V – 5V
Output Modes Digital and Analog
PCB Size 3 cm x 1.6 cm
Comparator Chip LM393
Interface 4-Wire (VCC, GND, DO, AO)
Power Consumption <20 mA
Detection Range Adjustable via potentiometer
Dimensions 30 mm x 16 mm
Add to wishlist Compare Quick view
₹ 170Specifications:
Microcontroller: STM32F103C8T6Core: ARM Cortex-M3 32-bit CPUOperating Frequency: 72MHzFlash Memory: 64KBSRAM: 20KBPower Supply: 2.0V – 3.6VDebugging Interface: SWD (Serial Wire Debug)Clock: 4-16MHz crystalDimensions: 54mm × 22mmWeight: 9g
End of content
End of content
Load more
IIC/I2C Serial Interface Adapter Module 
