Showing 21–30 of 30 results

  • GT POWER 3-Channel Multi Servo Tester ESC RC Consistency CCPM Master Speed Control

    GT POWER 3-Channel Multi Servo Tester ESC RC Consistency CCPM Master Speed Control

    0 out of 5
    ₹160

    📌 Specifications

    🔹 Operating Voltage: 4.8V – 6V DC
    🔹 Output Current: 15mA (5.0V)
    🔹 Output Signal: 1.5ms ± 0.5ms
    🔹 Dimensions: 35mm x 30mm x 15mm
    🔹 Knob Diameter: 12mm
    🔹 Weight: 8g
    🔹 Color: Blue

    Add to cartDone
  • L298N Based Motor Driver Module for DIY Projects

    L298N Based Motor Driver Module for DIY Projects

    0 out of 5
    ₹150

    Specifications

    • Operating Supply Voltage: Up to 46V
    • Total DC Current: Up to 4A (2A per channel)
    • Logic Voltage: 5V
    • Drive Voltage: 5V – 35V
    • Logic Current: 0-36mA
    • Drive Current: 2A (max per bridge)
    • Maximum Power: 25W
    • Dimensions: 44 x 44 x 28 mm (LxWxH)
    • Weight: 26g
    Add to cartDone
  • Node MCU ESP8266 with CP2102 Wi-Fi Development Board

    Node MCU ESP8266 with CP2102 Wi-Fi Development Board

    0 out of 5
    ₹250

    Specifications:

    • WiFi Module: ESP-12E
    • Processor: ESP8266
    • CP2102 Chip
    • Built-in Flash: 32Mbit
    • Antenna: Onboard PCB antenna
    • Peripheral interface: UART/SPI/I2C/SDIO/GPIO/ADC/PWM
    • WiFi Protocol: IEEE 802.11 b/g/n
    • Frequency Range: 2.4G ~ 2.5G (2400M ~ 2483.5M)
    • WiFi Mode: Station / SoftAP / SoftAP Station
    • Power Supply: 5V
    • Logic Level: 3.3V
    Add to cartDone
  • Raspberry Pi Pico W

    Raspberry Pi Pico W

    0 out of 5
    ₹650

    Specifications:

    • Product: Raspberry Pi Pico W
    • Microcontroller: RP2040
    • Flash Memory: 2MB
    • Processor: Dual-core Cortex-M0+ (up to 133MHz)
    • On-board single-band 2.4GHz wireless interfaces (802.11n)
    • Micro USB B port for power and data
    • 40 pin 21mmx51mm ‘DIP’ style 1mm thick PCB
    • 23 GPIO are digital-only, with three also being ADC capable
    Add to cartDone
  • SD Card Reading Writing Module for Arduino

    SD Card Reading Writing Module for Arduino

    0 out of 5
    ₹100

    QUICK OVERVIEW:

    • All SD SPI pins output, MOSI, SCK, MISO, and CS.
    • Support 5V/3.3V input.
    • This module can handle 2GB SD cards.
    • Size:4.7  x 3.1 cm.
    • LED indicator.
    • SD Card Holder.
    • Onboard 3.3V regulator (AMS1117-3.3) for +5v to 3.3V generation. 3.3V is also available as output.
    Add to cartDone
  • Servo SG90 9g 180 Degree Motor for Arduino

    Servo SG90 9g 180 Degree Motor for Arduino

    0 out of 5
    ₹90

    Specifications:

    • Universal for JR and FP connector § Cable length: 25cm
    • No load; Operating speed:

    0.12 sec / 60 degree (4.8V),

    0.10 sec / 60 degree (6.0V)

    • Temperature: -30~60’C
    • Dead band width: 5us
    Add to cartDone
  • SimonK 30A BLDC ESC Electronic Speed Controller

    SimonK 30A BLDC ESC Electronic Speed Controller

    0 out of 5
    ₹370

    Specifications

    • Operating Voltage: 2-3S LiPo Battery
    • Current Rating: 30A Continuous, 40A Peak
    • BEC Output: 5V/2A
    • Start Modes: Normal, Soft, Super-Soft
    • Compatibility: Fixed-wing aircraft, helicopters, multi-rotors
    • Safety Features: Backward-polarity protection, 5V receiver line protection
    • Heat Management: Heat sink with thermal membrane
    • Programmability: Fully programmable via RC remote control
    Add to cartDone
  • STM32F103C8T6 Minimum System Development Board

    STM32F103C8T6 Minimum System Development Board

    0 out of 5
    ₹200

    Specifications:

    • Microcontroller: STM32F103C8T6
    • Core: ARM Cortex-M3 32-bit CPU
    • Operating Frequency: 72MHz
    • Flash Memory: 64KB
    • SRAM: 20KB
    • Power Supply: 2.0V – 3.6V
    • Debugging Interface: SWD (Serial Wire Debug)
    • Clock: 4-16MHz crystal
    • Dimensions: 54mm × 22mm
    • Weight: 9g
    Read moreDone
  • Submersible Mini Water Pump 3-6V DC

    Submersible Mini Water Pump 3-6V DC

    0 out of 5
    ₹70

    Specifications:

    • Operating Voltage: 2.5 ~ 6V
    • Operating Current: 130 ~ 220mA
    • Flow Rate: 80 ~ 120 L/H
    • Maximum Lift: 40 ~ 110 mm
    • Outlet Outside Diameter: 7.5 mm
    • Outlet Inside Diameter: 5 mm
    Add to cartDone
  • TowerPro MG995 Metal Gear Servo Motor (180° Rotation)

    TowerPro MG995 Metal Gear Servo Motor (180° Rotation)

    0 out of 5
    ₹280

    Specifications

    Parameter Value
    Model MG995
    Weight 55g
    Operating Voltage 4.8V – 7.2V
    Torque @ 4.8V 10kg/cm
    Torque @ 6.6V 12kg/cm
    Operating Speed @ 4.8V 0.20 sec/60°
    Operating Speed @ 6.6V 0.16 sec/60°
    Rotational Angle 180° (±90°)
    Dead Band Width 1 µs

     

    Add to cartDone

End of content

End of content